Make Two Molds Into One Large Mold

90.00286.00

Clear

The price stated is for TWO molds

Make TWO Molds Into One Large Mold!

Firstly, we are able to make epoxy resin molds of any size!

Epoxy resin molds from rivertables.es are made with 12mm (1/2″) HDPE. The sides are 7cm (2.75″) high.

We are able to make two seperate molds that can join to make one large one.

This is done by you removing the two internal sides and connecting the two molds together using a standard packing tape (epoxy resin will not stick to packing tape).

Because all our molds are machined cut, the connected sides are seamless.

The galvanised threaded inserts connect the sides of the molds with machine screws, which allow for easy assembly and de-molding. Plus, the sides are straight, not tapered like some of the ones welded on the market, leading to less wasted resin and less finishing work.

You can construct the epoxy resin mold in under a couple of minutes.

The only additional requirement is the sealing of the edges with a standard silicon.

You then have this options, for example:

a) 3 Molds for the price of 2

b) Substantial saving on delivery costs as the size of the parcel is reduced.

2No. 60cm x 60cm Will give you a single mold size of 120cm x 60cm

2No. 60cm x 30cm Will give you a single mold size of 120cm x 30cm

2No. 60cm x 40cm Will give you a single mold size of 120cm x 40cm

2No. 30cm x 30cm Will give you a single mold size of 60cm x 30cm

2No. 40cm x 40cm Will give you a single mold size of 80cm x 40cm

2No. 20cm x 20cm Will give you a single mould size of 40cm x 20cm

Its non-adhesive quality does away with the need to use any kind of release spray or duct tape. Furthermore, the molds are completely reusable. You can reuse the mold, potentially, an infinite number of times.

HDPE is an expensive material.

However only the surface of the HDPE comes into contact with the resin, therefore there is little need to pay extra for very thick molds.

So, there is little point in going to the expense of purchasing very thick Plastic molds. When really all that you need is the HDPE surface.

Why are they cheaper than our competitors?

We are also able to sell our epoxy resin molds much cheaper than our competitors as we have done away with unnecessary extras. Small bubble spirit levels are notoriously unreliable. Particularly when attached to the removable sides of the mold. You should place the mold on a sturdy flat surface. You should then level this flat surface using a long spirit level. This will then negate the requirement for adjustable feet.

Are you sick of:

a) the time it takes having to make a different mold for every project? or

b) having your mold stick to your project when it comes the time to remove it? or

c) having to tape your mold prior to pouring the resin? Then a HDPE mold is definitely for you!

Why you should buy our epoxy resin HDPE molds?

  1. We machine cut to size all of the mold pieces and secure them with threaded inserts and bolts. As a result the sides are easily attached and detached.
  2. Easy assembly and de-molding.
  3. Our sides are straight, not tapered like some of the welded HDPE moulds on the market. Leading to less wasted resin and less finishing work.
  4. You can construct the mold in under a couple of minutes.
  5. You have to seal the edges with a standard silicon. That is the only additional requirement, as is the case with the majority of molds.
    The molds come in a variety of sizes.

All other sizes please contact us!

All measurements are +/- 2mm unless otherwise requested.